SPLIT-TRAY SETUP
Unpack. Connect. Set up.
A separate controller, two trays and connecting cables.
01 / 03ALL-IN-ONE SWEAT CARE
Your routine.
Thoughtfully redesigned.
Hynolur All-in-One · Hands & Feet
Integrated controls. A clear display. Four soft cotton pads. Everything brought together for a simpler at-home routine.
$198.00Online ordering is not open yet
Silver / White
100-day trial5-year warrantyFree shipping
- All-in-one tray and control panel
- High-frequency pulsed output
- Adjustable current and voltage limit
- Clear voltage, current and time display
01 / PULSED CURRENT
Designed for a more comfortable experience.
10kHz
10,000 pulses per second
High-frequency pulsed output brings controlled pauses to your sweat-care routine.
02 / LOCALIZED CURRENT PATH
From fingertips to palm.
For greater peace of mind.
The illustrated current path stays local to each hand, connecting the fingertip and palm contact areas.
Fingertip contactPalm contact
03 / ALL-IN-ONE CONVENIENCE
Less setup. More simplicity.
No separate controller. No tray cables.
HYNOLUR
One device. Ready together.
Tray, display and controls in one integrated design.
04 / CONTROL YOUR SETTINGS
Adjustable current.
A voltage limit you set.
View the control diagramAdjust current
Press + / −
2–30 mAUse the plus and minus buttons to adjust the current.
Set session time
Hold + for 3 seconds
Gradual ramp-downWhen the timer ends, voltage gradually decreases for more comfortable hand removal.
Set voltage limit
Hold − for 3 seconds
20–42 VThis is a ceiling. Voltage will not rise above it, even if the selected current cannot be reached.
Switch modes
Use the power button
+ Fingertips / − PalmThe symbol below the battery indicator shows the mode: + means stronger at the fingertips; − means stronger at the palm.
READY, SET, ROUTINE
4 simple steps.
Add tap water
Add the amount specified in the user manual. Keep water below the centre divider so the two areas remain separate.
Power on
Press the power button and check the display.
Adjust current
Use the + / − buttons to adjust the current.
Place both hands
Rest both hands flat on the pads and maintain steady contact, with thumbs in the centre recess.
YOUR PERSONAL ROUTINE
Hand sweating severity
& usage guide.
Mild
Your hands sweat when you feel nervous or excited, or in hot conditions, but become dry again relatively quickly.
Moderate
Your hands sweat several times a day. Each episode lasts longer, and it may take hours for them to dry naturally.
Severe
Your hands sweat almost constantly, regardless of your surroundings or emotions, with few lasting dry periods.
| Severity | Total timeacross multiple days | Suggested currentWomen | Suggested currentMen |
|---|---|---|---|
| Mild | 90–120 min | 10 mA | 15 mA |
| Moderate | 130–170 min | 15 mA | 20 mA |
| Severe | 175–230 min | 20 mA | 25 mA |
Use consistently for 4–15 days
Assess changes after 4–15 days of consistent use. Do not expect sweating to decrease after every single session.
20 minutes per session
Start with one session per day. No more than two sessions per day, spaced more than 8 hours apart.
Maintenance: every 3–7 days
When light sweating returns, use once every 3–7 days. For example, if 100 minutes of initial use achieved dryness, allow 20 minutes for maintenance — one-fifth of the initial time.
If one maintenance session is not enough, continue with further sessions until satisfied.
Adjust cumulative time to your tolerance
Example: The suggested current is 20 mA, with a total of 150 minutes, but you can only tolerate 10 mA.
Current ratio20 ÷ 10 = 2
Adjusted total150 × 2 = 300 min
Keep each session at 20 minutes: 15 sessions in total, spread over multiple days.
Maintenance time also approximately doubles.
For example, 20 minutes becomes 40 minutes, split into two 20-minute sessions.
Max. 2 sessions per day, more than 8 hours apart.
Stop use if significant pain or an unusual skin reaction occurs.
READ BEFORE USE
Important precautions.
Do not use if…
You are pregnant, have an irregular heartbeat, or have metal implants such as orthopedic pins.
Use by children
Children under 12 must be supervised by a parent or guardian.
Skin conditions & discomfort
Not recommended for unusually sensitive skin, including dyshidrotic eczema or sensitivity to electrical stimulation.
Use may cause pain, itching, redness, peeling, blisters or broken skin. Stop use and consult a healthcare professional if significant discomfort occurs.
Remove metal jewelry
Do not wear metal jewelry on the hands or feet being used with the device.
Care & replacement parts
Aluminum plates may oxidize and darken after use.
Water above 60°C (140°F) may deform the isolation mesh. This is not a manufacturing defect.
Aluminum plates and isolation mesh are consumable parts. Replacement parts can be purchased separately.
What to expect
This product has no therapeutic effect. No product can guarantee completely sweat-free skin; sweat reduction is temporary.
Results and how long they last vary.